r/PS4Pro • u/ZochoK • Aug 20 '23

PS4 Pro Broken PSU connector

Hi.

Today, during opening of my ps4 pro I unfortunately damaged PSU connector. 2 of 4 pads are gone from motherboard. I come here for a little help.

Does someone knows where I can solder cables onto motherboard to fix does 2 pads?

Don't worry about this mess. It's the rest of the glue. Not conductive anyway

​

I found following pinout in my PSU. I also found this picture on the internet, but when I checking connection between followed "+5V SBY" point and my first pin "5VSB" I got nothing. GND point works as it should.

​

https://www.psxhax.com/threads/playstation-4-pro-power-supply-pinout-help.2950/page-4

Can someone help me? The only pinout that I found said that one of the pins should be empty, but it doesn't match description inside PSU.

​

ADP-300ER

My console model is CUH-7116B

Regards

2 Upvotes

75% Upvoted

10 comments sorted by

2

u/ZochoK Aug 23 '23

Thanks for the all replies. I'm glad to inform that the console is working again. For future fellows that will have a similar problem, I wanna mention that "+5V SBY" from the second picture goes to the "ACIN_DET" pad, and, of course, "ACDC_STBY" goes to "ACDC_STBY". I didn't check where the "5VSB" pad goes, but I will check and share when I finally fixed it. For now, I'm waiting for a proper glue to mount the connector on the motherboard. Right now I just soldered it with cables to the points

1

u/Liliputzz Dec 26 '24

Hey Im glad you made it work, could you let me know how did you do it? Im having the same issue right now

1

u/ZochoK Feb 05 '25

Hi. Sorry, but I was out of reddit for sometime. Do you still need any help?

1

u/Liliputzz Feb 05 '25

I’ve fixed it by checking out ps4 pro motherboard layout and connecting wires to it, thanks for asking. Take care

1

u/romikk82 Aug 20 '23

Unfortunately this is typical issue with PS4. Any decent electronics repair shop should be able to fix that. I don't advise trying to repair it yourself, since it's very easy to make bad situation worse.

1

u/ray_ray696 Aug 21 '23

I too was having a problem removing this cable from the board so instead I unplugged it from the power supply unit which comes off very easily.

1

u/Imaginary_Act1090 Aug 23 '23

I would just connect it to the via and make a new trace, solder most of it down and glue the connector down. Thats a lot of damage my friend, made me say “daaaamn, you fucked up good”