r/GolfMk2 • u/willgchurch1 • 6d ago

Agg/pg build

Post image

I’ve scored a great job lot of engine bits including an agg block and a very good condition pg(g60) head.

I’ve already stripped the block down and have ordered new bearings and a gasket kit. And given both the block and head a good clean and a lick of paint

I’m planning on running the digi setup and possibly down the line adding a turbo. But is there anything that could be an issue running the pg head on the agg block?

A standalone ecu isn’t out of the question but would like to remain as stock as possible. Hopefully running the distributor ect

Has anyone done a build like this before? I can’t find much online
Cheers !

17 Upvotes

96% Upvoted

5 comments sorted by

2

u/XenomorphNr6 6d ago

Looks nice 👍🏻 Unfortunately I cannot help you with this matter as I've never done extensive engine work, I'm just here to tell you good luck with this build I hope it works out :)

1

u/LithiuM23 5d ago

Are you doing forged pistons? If so I recommend Wossners. I put them in my G60 and VR6.

1

u/Klutzy_Control8370 4d ago

I have 2e (similar with agg) with PB head with is also quite similar to the g60 one. Running digifant 2 without any issues.

1

u/willgchurch1 4d ago

Nice, that’s good to know. I’ll probably run it like that for a while then rethink about more power. But luckily all I need to swap to digi is a loom

1

u/Klutzy_Control8370 4d ago

When I did the block swap I was impressed by the torque gains compared to the 1.8 PB but now, after 3 years I am also seeking mo' powa' baby:)))