So I side quested today and made a goatee bead and piercing to go with my fit before I leave.

For the goatee bead, I went with a tooth cause I don’t know why, aside from it sounded cool. It was a free file I punched a hole in.
I did also have a snake vertebrae file, but it printed too big and hole too small for the goatee, so maybe I redo that smaller instead of or addition to the tooth?

The piercing I found a 3d scan of a fossilised rib bone, shrunk that and added the saddle/plug section, and then a little fake rope stopper. (I have 8mm stretchers)
Not sure what to do on my other ear though, didn’t want to just do the same as the other, maybe just my normal wood plug. Ideas welcome

Do these ideas work? or too far off the mark??

Bonus extra since it’s in shot, my hand tattoo is a ruler as the diamonds (10mm apart, first starting at 30mm), and the compass is a protractor (11.25* apart, with diamonds on the 45* increments)

This board took me two months but I finally got there 🙌🏻

#freehand #pyrography #kraken #ship #monster

Location: Bristol Ren Faire

That is the character I'm coming up with for next festival but this is really me showing off the coat I just finished