Sold this thing with 600 miles on it due to kids etc 8 years ago and I regret it everyday

This bike feels so good to ride. 12.000 km doing mostly offroad and no big problems.

Went out for my weekly ride with my crew and was super excited to finally take my Austin Racing RS22 full Ti exhaust out for a ride after waiting months for it. Unfortunately, it ended up melting the inside heels of my Alpinestars LE Martin Supertech R boots, which I absolutely love. 😭

Now I’m trying to figure out how to remove all the melted plastic from the pipe without scratching or damaging the titanium, while also finding a solution to keep it from happening again.

Any ideas or suggestions would be greatly appreciated! I seriously doubt Alpinestars will be able to repair the boots, and I doubt even more that Austin Racing would replace the section of the pipe with the melted plastic stuck to it.

Really frustrating after waiting months for the exhaust, only for it to end up destroying one of my favorite pairs of boots.

Recently I posted a Sale Ad for my KTM 390 Adventure which has run 63,000kms and still remain as good as new with factory compression restored. Over the past few days, I got the opportunity to chat with a lot of fellow bikers who struggled to keep up their engines on a longer run and asked if I did anything to maintain it better?

Well, below is the holy grail of Routine maintenance checks that I have created, and I shared it with them too.

I had run it specifically for KTM 390 Adventure, so same applies to any bike in the category (single cylinder under 500cc adventure bike). It would be awesome if larger and multiple cylinder owners could share their thoughts in the comments. Road biased bikes are welcome to share too. Let's make this knowledge useful 😁🤘

Hope it benefits all fellow riders. Ride Hard and Ride Safe 🫡

MOTORCYCLE MAINTENANCE CHECKLIST

[ 5,000 KM - ROUTINE INTERVAL SERVICE ]

-----------------------------------------------------

REPLACE:

• Engine Oil & Oil Filter (with new O-rings)

CHECK / CLEAN / ADJUST:

• Air Filter: Wash/re-oil (BMC) or clean out dust (Paper)

• Drive Chain: Deep clean, lube, adjust tension (25-30 mm)

• Brake Pads: Check thickness (replace if < 2 mm)

• Cables: Adjust clutch/throttle free play; lube cable barrels

• Fasteners & Battery: Check terminal tightness & charging volts (13.8V-14.4V)

[ 15,000 KM - MAJOR SERVICE ]

--------------------------------------------------

REPLACE:

• Spark Plug: New OEM / Iridium plug

• Brake Fluid: Complete flush & bleed front and rear (DOT 4/5.1)

• Fork Oil: Drain old fluid, flush internals, refill fresh oil

CHECK / CLEAN / ADJUST:

• Valve Clearances: Inspect with feeler gauges; reshim if tight

• Steering Stem (Cone Set): Check for play/notchiness; clean & repack grease

• Throttle Body: Clean carbon from butterfly valve and bore

[ 30,000 KM - SYSTEMS & CHASSIS ]

------------------------------------‐---------------------

REPLACE:

• Engine Coolant: Drain, flush with distilled water, refill

• Fuel Pump Strainer: Replace in-tank tea bag filter

• Fork Seals & Dust Caps: Replace alongside fork oil

• Air Filter: Replace (if using stock OEM paper unit)

• Chain & Sprocket Kit: Replace complete set (chain + both sprockets)

CHECK / INSPECT:

• Wheel Bearings: Check front/rear for roughness or lateral play

• Brake Discs: Measure thickness against minimum stamped limit

[ 45,000 - 50,000 KM - INTERNAL OVERHAUL ]

----------------------------------------------------------------

REPLACE:

• Timing Chain & Tensioner: Replace to prevent slack and timing jumps

• Clutch Plates & Springs: Replace if slipping under hard acceleration

• Valve Stem Seals: Replace to prevent top-end oil burning

CHECK / INSPECT:

• Cylinder Compression: Run compression test to evaluate piston ring wear

• Swingarm Bushings: Check for side-to-side play; regrease pivot axle

KTM RC 200 BS3 oil leak

Hey everyone, I have a KTM RC 200 BS3 and I recently noticed a oil leak from the engine area.

I already got the seal replaced recently. After that, I cleaned the entire area properly with WD-40 but suddenly today I will notice this kinda oil near my stand and on engine I'm already invested so much in this bike what I have to do

My clutch lever adjuster dont work anymore it seems like stuck , anyone know how to make it work again ?

2021 sxf 16 hours for 4k couldn’t resist

I had the same issue lately (at 6700km), few hundreds km later after oil change (probably wasn't the cause), developed this chain rattling/oil light issue. Illuminated from 4s to even 10-15s after hot restart, later once or twice it did it even at cold start. I only used 10w50 Motorex, as manufacturer recommends. Changed oil and filters religiously (original KTM) between 1700-2300km (now after 1200km).

First thing I did:
- changed the oil pressure relief valve and spring - spring was actually a bit shorter than new one and would recommend to do it as a preventive maintance. It's easy job and it is already described on this forum.
- it stopped doing it, but after next hot engine restart (35km+, full throttle), same issue, I developed headache at this time, because I've read all horor stories at ktmforums, where they changed engine case, piston, later even whole engine in warranty and hold your hat, it didn't help (including changing tensioner, checking oil pumps, changing oil and filters, sensor, etc.)

Second thing I did:
- friend of mine recommended using 15w60 Motul 300v Offroad
- didn't believe him fully at first and just to be sure I've watched pirateracing guy, who recommends this oil due to all kind of reasons, if I remeber correctly it was mostly for bearings and oil drain back prevention, (btw Motorex pays to KTM for being used in all their products - I didn't know that - maybe you do)
- pirateracing recommends also to change O ring on tensioner (I didn't do it), that likes to fail (all procedure and wisdom is searchable at his youtube channel)
- one negative is you have to change oil earlier (2500-3000km max), but I did it anyways earlier with 10w50 Motorex, so no issue for me

And olala, problem solved, did 100-150km already, and no issue, rattling went away, oil light always goes off mostly in 1s, max 2s, quickshifter and shifting generally is smoother, engine is a little bit quiter and no false neutrals.

Give it a try, it's cheapest solution and I've read all kind of threads, forums and nothing helped, except this oil alternative and changing oil relief pressure valve and spring, plus cleaning tube which connects to oil pressure sensor could be clogged, but that couldn't be my case due to chain rattle sound. Faulty oil pressure sensor was ruled out as well.

I'm not saying it will work for all of you, but it worked for a lot of people. Maybe it will start to do it again, but I did already at least 15-20 hot restarts and it didn't do it at all.

I could put there video, if u want, what it exactly did to me (I filmed it once), but it's all the same and you can filter it up on youtube/facebook, there is a lot of +- similar stories.
/edit: video is already uploaded in the comment section

I had to share it, because I scratched my head for a long time and can confirm, that it fixed at least my issues officialy.

ktmforums:
https://www.ktmforum.eu/forum/thread/119440-%C3%B6ldruckwarnlampe-leuchtet-zu-lange-smc-r-2018-2024/?pageNo=14

pirateracing:
https://youtu.be/7YYAoO2Avcw

Thank you for reading it all and hopefully it will help to you as well.

Up here the season likely ends around october.

It starts getting colder and frost starts being a concern, as well the authum leafs, so I need to make every day count for the next month or so. :)

Had the bike for a few months now, still loving it.

Main complaint so far is that the navigation works great, but does not integrate with the phone and does not have voice prompts either. Since it is easy to enter addresses with the touch screen it is not that bad, but it would be nice to load gpx files when planning routes from the confort of the couch :)

Fellow **Calcuttans** riding a KTM, which service centre do you swear by in our city?
Would love to know your experiences and recommendations. 🙌

A new 'ADV 390' owner (shifted from Yezdi Scrambler's sheer painful after sales, so what am i looking at?)