Project.

Hi there!

I have a Bosch High Pressure sensor 

https://www.speedingparts.eu/p/engine-management-electronics/engine-control/sensors/pressure-sensor/bosch-high-pressure-sensor-m10x1-0-261-545-188.html

It states m10x1mm thread and in other sources it mentions 45 degree cone tip.

Because my brake lines use m12x1mm I have a T-connector 

https://www.automotive-line.nl/product/remleiding-t-connector-m12-x-1-00-mm-al-128/

And adaptor 

https://www.automotive-line.nl/product/remleiding-verloopnippel-m10-x-1-00-m12-x-1-00/

The question is, I'm not sure that the adapter and sensor connections will be tight and right for this application.

Does anyone have experience with connecting it tightly?

TIA

Motorsports Event.